You can buy one at Wal-Mart for under a hundred dollars. However, if you want it to quality and patient you must build it yourself.
Step 1 - Set Post
You need to put on a spot in the earth. If you know how to put a fence post, it's the same. Just to dig the hole one third the length of the post. Fill the hole with two 80 kg bags of concrete. Set the post with a post-level. Finally, water mix into the hole with a shovel or dig a bar. They areNeed for a message that is at least 8 feet tall. It depends on how high you to be the shower.
Step 2 - Drill Post
Around the PVC pipe in the mail, you must put a large hole drilled at the bottom. Use a wood-boring (spade type) Drill a hole just large enough to slide the pipe through the hole. Slide through the pipe, and plumb the post.
Step 3 - Plumb Post
Buy a couple of schedule 40 PVC pipe, some metal pipe, belts, about two inches of wood screws andSome blue PVC glue. Glue the pipe together as desired and then screw the pipe strap to the post office holds the tube in the post.
Step 4 - In shower head
Bring a threaded elbow on the end of the tube where you want the shower to be. Then get a close male threaded nipple for attaching the shower head and pipe. Do not forget to use three rounds of Teflon tape on nipple.
Step 5 - Hook Up Water
For connecting hose, install a hose connector on theEnd of the PVC pipe that goes through the bottom of the post. Connect the hose whenever you want to shower or just leave it plugged in and turn the water in the shower. This is probably the easiest method.
You have the option of the home hot water and pulls the line out on to the shower. This is a better but more expensive.
Step 6 - The Base
For an occasional shower, you do not have any kind of base or drainage. It isespecially for preference shares. You can build a small wooden deck, or to put a number of large plates in the shower.
0 ความคิดเห็น:
แสดงความคิดเห็น