A kettle is a device that we rarely think about until there is no hot water, or until it leaks. Then it will be the focus of attention. Spending a little time each year the inspection and maintenance will add years of useful and safe life to this important device.
Use the following simple steps to examine your water heater once a year. Always read and follow the instructions of the manufacturer to conduct inspections and maintenance. If youUncertain about what to do on a professional show you how.
Check the general condition. Call a qualified plumber if rust or corrosion is severe when water runs out pipes or storage tanks, or where electrical and gas connections seem loose or deteriorated.
Drain sediment from the tank. Sediment of the appliance can result in more energy and can accelerate deterioration of the tank, so that a leak out. Before you begin, turn electrical devices in theCircuit breaker or fuse in the cabinet, or set the gas valve control on gas installations. Turn the water valve on the water supply to the appliance (usually the right side of tube). Attach a hose to the drain port on the bottom of the device and run the hose outside or inside a floor drain. Open the drain valve. Drain a few gallons of water from the device, until the water remains clear. Close the drain valve andRemove the hose. Turn the cold water valve. Turn the power or turn the gas valve on the run setting. Check the drain plug. If it is dripping water after a few minutes, the valve can be defective. Call a qualified plumber, to assess the valve.
Test the temperature and pressure relief valve. This important safety device is located on the top or side of the water heater. This valve prevents that the device before the explosion, when the temperature or pressure in theTank reaches unsafe levels. Confirm that the valve is connected to a pressure line and that the tube ends in a place where you can not through the hot water from the boiler to be sprayed. If you are unsure about this, call a professional to help you. Raise your hand grip test (usually a silver color). Listen to flow water. Lower the test device to its original position. Note the pressure at the discharge point. If the water is stilldripped from the point of discharge after 24 hours, or if you do not hear the water does not flow when the handle, or if you still hear water flowing when you can close the test control, the valve is defective. Call a qualified plumber, to assess the valve. CAUTION: It is not uncommon for these leaky valves, when tested.
Check the temperature of the water. Use a thermometer that registers temperatures between 100 and 150 degrees. Perform only hot water from a sink faucetnear the water heater for a few minutes. Check the temperature of the water. If it is at or above 125 degrees the temperature is too high and not secure. Water over 125 degrees can cause scalding. Turn the water down at the water heater. Most gas water heaters have a thermostat easily visible on the gas valve. The thermostat for most electric water heaters is available under the bottom cover. WARNING: There are exposed electricalConnections to the ceiling. Do not open the cover, if you are familiar with electric water heaters. Call a professional to help you.
Replace the anode after about six years. The anode is a piece of metal in the tank, which falls slowly from the galvanic reaction between water and metal. The anode sacrifices himself so that not corrode the tank so fast. Once the anode is gone, the container will corrode and eventually leak. Some anodes are relatively easy to. Replace Others require a qualified plumber. Read the instructions on the anode replacement.
If you take care of your water heater, it will provide for you for many years. Inspection and maintenance takes only a few minutes per year, can prevent water damage from a leaking appliance, and can prove costly emergency-stop compensation.
0 ความคิดเห็น:
แสดงความคิดเห็น