Used or new outboard motors do not require regular care after every use. Outboard motors are not like car engines in the sense that they require more maintenance in the future than just every 3000 miles. Outboard motors have to deal with a lot more environmental elements than a normal car engine. To do the deed car engines do not leave with a lot of salt deposits of salt water use. Now they have to worry about constant water intrusions that with outboardby each operation. So it is no wonder that outboard motors will require maintenance after each use.
Measures that may be required to take after each trip with an outboard motor:
1. Rinse apply the engine - not just seawater tours, you can only so much damage to fresh water to salt water.
* Buy a pair of rabbit ears. This is a flexible rubber seal, a metal clip attached. This unit will help you flush the engine. Connect the device to the bottomPart of the engine were lifted the water. Connect a water hose to the back of the rabbit ears.
2. Start the engine and let the pump will work. The water pump will result in clean water and wash away all of salt or mood, which built up during your adventure could be left.
3. During the flushing of the engine check the water pump to see if your a good water drainage. Gently put your hand inthe stream of water. When the pumping of water is not difficult, then a block can have again the drain pipe. If so, stop the engine immediately and clear the rubble. You can do this by creating a small wire into the flow tube and they work back and forth. If you think the tube is removed, re-start the engine and check flow freely again.
4. Once the purging is complete the engine run off the gas line and the engine to the excess fuel in the. After more than fuelburned down put the fuel line again.
5. Next check for old and water leaks. This will be turned off the hood. If you consult with a link to take a boat to find a mechanic to have resolved the problem.
6. Once you have cleaned and checked everything that it is time to destroy everything and a spray with corrosion-like WD40 or Quick Lube.
7. Replace the cap and insert a plastic cover off the engine to prevent anything from getting in the engine.
That's it. Yourdone.
0 ความคิดเห็น:
แสดงความคิดเห็น