Pay more than you need for hot water is the same as pouring energy dollars down the sink. In this article you will learn to find his hands on the Council on how to keep your water heater for any price, that is an economical and ecological way of heating water. In time, you can expect your energy savings will more than pay for your first work investment.
Water Heater Maintenance
To keep your water heater to be free from debris and sedimentto work more efficiently, and this is especially important if you live in an area with hard water. As hard water is laden with minerals, this can build into your heating system and reduce its effectiveness.
So you would keep your water temperature below 120 degrees will slow sedimentation, and the water is usually hot enough for most household purposes (unless you love a hot shower). Dishwashers often require hot water, but mostModern dishwashers come with their own internal heaters that can raise the temperature of the water to the 140 degrees they need.
The removal of sediment
The sediments from your water heater drain it, set off by the water supply for the heater in the cold water at your home or the main shutoff valve. If you have a gas-fired heater, turn the temperature knob to OFF and close the gas valve to the gas line. If youhave an electric water heater, simply turn off the electricity at the main service panel.
Next, add a length of garden hose to drain the heater valve and run it into a floor drain in your basement or outside (but) at the level of heating. If you do not have a sufficient length of hose, place a bucket or pan under the drain, but be prepared to stop and go as you empty the buckets.
Open drain the heating system and shows a close the tap for hot water in the airYour water system. The water is first out of the valve. Once the water starts running clear, you can use the valve. If the water is still running clouds for a long time, then rinse the supply valve for the cold water to remove any remaining sediment.
When you are finished, close the drain valve and shut off the nearby hot water faucet. If you have not already done so, open the cold water faucet in the mineTank. Once the tank is full and you can no longer hear water running into it, turn off the power, either by restoring the power or open the gas line and fueling the pilot light. The sediments hold in check, you set your thermostat to below 120 degrees.
0 ความคิดเห็น:
แสดงความคิดเห็น