Sometimes go through a leaky Spicket that is on the outside of the house. If you live in the city, this could have the water bill is not much, but still a raise increase. If you live in the country, this might increase the electricity bill, because that keeps going well that supplies water.
Depending on the type of Spicket that you depend on the update. If you have a standard compression Spicket to circumvent a rule, the round metal on it, the leakcan handle from the stem, if so all you have to do is pull the packaging, the mother is the handle to buy. To do this, just a wrench and tight packing nut around the stem. Well not if the fix, and the grip is still leaking, or that the leak is coming from the spot, we will have to bear, to take over the Spicket apart.
Therefore we want to start by shutting off the water to the Spicket. This is to take place usually in the basement or crawl space. Well, if youHouse sits on a concrete slab, it is one of two things you can do. One is, turns off the water supply to the whole house, or if you are lucky enough to install the plumbers and for those Spicket they probably do not shut down, you can turn that off. The same applies if you do not have a shut down in the basement for the Spicket, you need to shut off the main to the house. Now the most important, the house is a great indicator, as has been known, you did the water meter. It is an outlet near you. Warning! NOT close the valve, which in the METER GOES. These can be found in a lot of trouble manipulating it. The valve that we want is on the meter from the water.
With the water turned off, in his time to work. Now you go out and turn and open the valve and release water that is in the pipes from the inside valve to the Spicket. Would you have turned off the main every lamp go into the house and open it to the release> Water and the Spicket go and open it. This will remove any water from the house and then you do not use water to come a surprise to you.
Well, if the stem is leaking, we will want to remove a portion of the Spicket. To achieve this, we will need an adjustable wrench. Behind this packing nut is a place that you can place an adjustable wrench and unscrew the assembly. Completely unscrew the packing assembly and remove it from theSpicket. Now we will want to get the packing nut washer. For this we need to unscrew the handle to the meeting. There should be a nut or bolt at the top of the handle, you can solve. Screw you remove it and the handle.
Next, go to try and unscrew the packing nut to remove. Within the parent you find yourself in some kind of disk, either a rubber sealing washer or graphite packing string. Remove and replace with a new one right either. Well, if you can not find amatching washer for the packaging of the mother, you can Graphite sting. Wrap the string around the trunk and push the washer on the packaging, and tighten it. You can do this by using a flat blade screwdriver. The reversal of the steps first presented by reinstalling the package with the mother, in the grip assembly, put the unit back into the Spicket, and tighten.
Now if the Spicket was leaking from the spout, all the first steps are the same, the Assembly from the Spicket. Then you aregoing to want to replace the compression plate, which is on the underside of the assembly. Loosen the nut that holds it in position and replace the disc with him an exact match size and shape. Re-screw the screw to hold the assembly of the disc. Then install the unit back into the Spicket. With the newly installed Spicket it is safe to turn on the water again. Make sure that all faucets in the house that you opened to be closed first.
0 ความคิดเห็น:
แสดงความคิดเห็น